Kramer Electronics vs-48hdcpx1 6.5 Locking and Unlocking the Front Panel , 6.6 Resetting the Ethernet Configuration to Default Values , 6.7 Controlling Configuration via the Ethernet Port , 6.8 Firmware Upgrade

1 30

VS-48HDCPxl - Operating the VS-48HDCPxl 4x8 DVI Matrix Switcher

4. Press the EDID button.

The process is complete when the display returns to normal.

6.5 Locking and Unlocking the Front Panel

To prevent unintended tampering with the unit via the front panel buttons, lock

your VS-48HDCPxl.

To lock the VS-48HDCPxl:

 Press the PANEL LOCK button on the front

6.6 Resetting the Ethernet Configuration to Default Values

Power cycle the unit while holding in the Factory Reset button, located on the rear

panel of the unit.

6.7 Controlling Configuration via the Ethernet Port

To control several units via Ethernet, connect the Master unit (Machine # 1)

Ethernet port on your PC. Use your PC to configure the initial settings (see

Section 5.1).

6.8 Firmware Upgrade

Instructions for upgrading the firmware can be found in the STC Firmware

Upgrade document.

Contents

Main USE R MAN UAL Page Page 1 Introduction 2 Getting Started ! 2.1 Achieving the Best Performance 2.2 Safety Instructions ! 2.3 Recycling Kramer Products 3 Overview 3.1 Defining the VS-48HDCPxl 4x8 DVI Matrix Switcher Page Page 3.2 Using the IR Transmitter 4 Installing in a Rack 5 Connecting the VS-48HDCPxl 5.1 Connecting to the VS-48HDCPxl via RS-232 5.2 Operating via Ethernet i 5.2.1 Connecting the Ethernet Port directly to a PC Page Page 15 5.2.2 Connecting the Ethernet Port via a Network Hub or Switch 5.2.3 Control Configuration via the Ethernet Port 6 Operating the VS-48HDCPxl 4x8 DVI Matrix Switcher 6.1 Routing Inputs to Outputs 6.2 Disconnecting the Outputs 6.3 Storing and Recalling a Setup Page 6.4 Acquiring the EDID 6.4.1 Acquiring an EDID from a Single Connected Output 6.4.2 Acquiring an EDID from Several Sets of Inputs and Outputs 19 6.4.3 Acquiring the Default EDID 6.5 Locking and Unlocking the Front Panel 6.6 Resetting the Ethernet Configuration to Default Values 6.7 Controlling Configuration via the Ethernet Port 6.8 Firmware Upgrade 7 Technical Specifications 8 Default Communication Parameters 9 Kramer Protocol 2000 i 24 VS-48HDCPxl - Kramer Protocol 2000 Input Description Definition for Specific Instruction Page Page !