Kramer Electronics vs-48hdcpx1 15 , 5.2.2 Connecting the Ethernet Port via a Network Hub or Switch , 5.2.3 Control Configuration via the Ethernet Port

1 30

VS-48HDCPxl - Connecting the VS-48HDCPxl

6. Select Use the following IP Address for static IP addressing and fill in the

details as shown in Figure 7.

For TCP/IPv4 you can use any IP address in the range 192.168.1.1 to

192.168.1.255 (excluding 192.168.1.39) that is provided by your IT

department.

Figure 7: Internet Protocol Properties Window

7. Click OK.

8. Click Close.

5.2.2 Connecting the Ethernet Port via a Network Hub or Switch

You can connect the Ethernet port of the VS-48HDCPxl to the Ethernet port on a

network hub or using a straight-through cable with RJ-45 connectors.

5.2.3 Control Configuration via the Ethernet Port

To control several units via Ethernet, connect the Master unit (Device 1) via the

Ethernet port to the Ethernet port of your PC. Use your PC provide initial

configuration of the settings (see Section 5.2).

Contents

Main USE R MAN UAL Page Page 1 Introduction 2 Getting Started ! 2.1 Achieving the Best Performance 2.2 Safety Instructions ! 2.3 Recycling Kramer Products 3 Overview 3.1 Defining the VS-48HDCPxl 4x8 DVI Matrix Switcher Page Page 3.2 Using the IR Transmitter 4 Installing in a Rack 5 Connecting the VS-48HDCPxl 5.1 Connecting to the VS-48HDCPxl via RS-232 5.2 Operating via Ethernet i 5.2.1 Connecting the Ethernet Port directly to a PC Page Page 15 5.2.2 Connecting the Ethernet Port via a Network Hub or Switch 5.2.3 Control Configuration via the Ethernet Port 6 Operating the VS-48HDCPxl 4x8 DVI Matrix Switcher 6.1 Routing Inputs to Outputs 6.2 Disconnecting the Outputs 6.3 Storing and Recalling a Setup Page 6.4 Acquiring the EDID 6.4.1 Acquiring an EDID from a Single Connected Output 6.4.2 Acquiring an EDID from Several Sets of Inputs and Outputs 19 6.4.3 Acquiring the Default EDID 6.5 Locking and Unlocking the Front Panel 6.6 Resetting the Ethernet Configuration to Default Values 6.7 Controlling Configuration via the Ethernet Port 6.8 Firmware Upgrade 7 Technical Specifications 8 Default Communication Parameters 9 Kramer Protocol 2000 i 24 VS-48HDCPxl - Kramer Protocol 2000 Input Description Definition for Specific Instruction Page Page !