Kramer Electronics vs-48hdcpx1 i

VS-48HDCPxl - Connecting the VS-48HDCPxl

You can connect to the VS-48HDCPxl via Ethernet using either of the following

methods:

 Directly to the PC using a crossover cable (see Section 5.2.1)

 Via a network hub, switch, or router, using a straight-through cable (see

Section 5.2.2)

Note: If you want to connect via a router and your IT system is based on IPv6,

speak to your IT department for specific installation instructions.

After connecting the Ethernet port, you have to install and configure your Ethernet Port. For

detailed instructions, see the “Ethernet Configuration (FC-11) guide.pdf” file in the technical

support section at http://www.kramerelectronics.com/support/faq.asp.

You can connect the Ethernet port of the VS-48HDCPxl directly to the Ethernet

port on your PC using a crossover cable with RJ-45 connectors.

This type of connection is recommended for identifying the

VS-48HDCPxl with the factory configured default IP address.

After connecting the VS-48HDCPxl to the Ethernet port, configure your PC as

follows:

1. Click Start > Control Panel > Network and Sharing Center.

2. Click Change Adapter Settings.

3. Highlight the network adapter you want to use to connect to the device and

click Change settings of this connection.

The Local Area Connection Properties window for the selected network

adapter appears as shown in Figure 4.