16
VS-48HDCPxl - Operating the VS-48HDCPxl 4x8 DVI Matrix Switcher
6 Operating the VS-48HDCPxl 4x8 DVI Matrix Switcher
This section describes how to:
Route inputs to outputs (see Section 6.1)
Disconnect outputs (see Section 6.2)
Store and recall a setup (see Section 6.3)
Acquire the EDID (see Section 6.4)
Lock and unlock the front panel (see Section 6.5)
Reset the Ethernet configuration to default values (see Section 6.6)
Control the machine via the Ethernet port (see Section 6.7)

6.1 Routing Inputs to Outputs

To route an input to an output:
Press an OUT key, followed by an IN key to route this input to that output
To route one input to all outputs:
Press ALL followed by an IN button. The input is routed to all outputs

6.2 Disconnecting the Outputs

To disconnect one output:
Press the OUT button of the output to disconnect and press OFF
To disconnect all outputs at once:
Press the ALL button and then press OFF. This disconnects all the outputs

6.3 Storing and Recalling a Setup

You can use the STO and RCL buttons to store up to 12 setups and then recall
them as illustrated in Figure 8.
IN 1 is used for setup number 1 and OUT 1 is used for setup number 5.