Kramer Electronics vs-48hdcpx1

VS-48HDCPxl - Connecting the VS-48HDCPxl

Figure 4: Local Area Connection Properties Window

4. Highlight either Internet Protocol Version 6 (TCP/IPv6) or Internet

Protocol Version 4 (TCP/IPv4) depending on the requirements of your IT

system.

5. Click Properties.

The Internet Protocol Properties window relevant to your IT system appears

as shown in Figure 5 or Figure 6.

Contents

Main USE R MAN UAL Page Page 1 Introduction 2 Getting Started ! 2.1 Achieving the Best Performance 2.2 Safety Instructions ! 2.3 Recycling Kramer Products 3 Overview 3.1 Defining the VS-48HDCPxl 4x8 DVI Matrix Switcher Page Page 3.2 Using the IR Transmitter 4 Installing in a Rack 5 Connecting the VS-48HDCPxl 5.1 Connecting to the VS-48HDCPxl via RS-232 5.2 Operating via Ethernet i 5.2.1 Connecting the Ethernet Port directly to a PC Page Page 15 5.2.2 Connecting the Ethernet Port via a Network Hub or Switch 5.2.3 Control Configuration via the Ethernet Port 6 Operating the VS-48HDCPxl 4x8 DVI Matrix Switcher 6.1 Routing Inputs to Outputs 6.2 Disconnecting the Outputs 6.3 Storing and Recalling a Setup Page 6.4 Acquiring the EDID 6.4.1 Acquiring an EDID from a Single Connected Output 6.4.2 Acquiring an EDID from Several Sets of Inputs and Outputs 19 6.4.3 Acquiring the Default EDID 6.5 Locking and Unlocking the Front Panel 6.6 Resetting the Ethernet Configuration to Default Values 6.7 Controlling Configuration via the Ethernet Port 6.8 Firmware Upgrade 7 Technical Specifications 8 Default Communication Parameters 9 Kramer Protocol 2000 i 24 VS-48HDCPxl - Kramer Protocol 2000 Input Description Definition for Specific Instruction Page Page !