|
| Defining the | ||
|
| Table 1: Front Panel | ||
|
|
|
|
|
| # | Feature | Function |
|
| 1 | IR Receiver | The red LED is illuminated when receiving signals from the |
|
|
|
| control transmitter |
|
| 2 | Power Switch | Illuminated switch for turning the unit ON or OFF |
|
| 3 | ALL Button | Pressing ALL followed by an BRANCH button, connects that BRANCH to all |
|
|
|
| LEAF devices1 |
|
| 4 | OFF Button | An |
|
|
|
| an |
|
| 5 | LEAF Buttons | Select 1 - 6 to connect between a BRANCH device and a LEAF device |
|
| 6 | BRANCH Buttons | Select 1 - 6 to connect between a LEAF device and a BRANCH device |
|
| 7 | STO (STORE) Button | Pressing STO followed by a LEAF button stores the current setting2 |
|
| 8 | RCL (RECALL) Button | Pressing the RCL button and the corresponding LEAF button recalls a setup |
|
|
|
| from the |
|
|
|
| LEAF button lets you view3 another setup. After making your choice, pressing |
|
|
|
| the RCL button again implements the new status |
|
| 9 | LOCK Button | Toggles engaging/disengaging the front panel switches. The button is lit |
|
|
|
| when the switches are locked (disengaged) |
|
| 10 | TAKE Button | Pressing TAKE toggles the mode between the CONFIRM mode4 and the AT |
|
|
|
| ONCE mode (user confirmation per action is unnecessary) |
|
| 11 | LEAF | Labels identify a cross point between each LEAF to which the BRANCH |
|
|
|
| displayed below it is connected |
|
| 12 | BRANCH |
| |
|
|
| the corresponding LEAF label) |
|
| 13 | PORT STATUS LEDs | Lights when data from an external device is detected on that port |
|
Table 2: Rear Panel VS-66FW 6 Port FireWire Switcher Features
# | Feature | Function |
1 | PORT | Connects to the FireWire device(s) (from 1 to 6) |
2 | Connects to the PC or the | |
3 | REMOTE Terminal Block | Connects to the Remote |
| Connector |
|
4 | Pin G is for Ground connection; Pins + and – are for | |
5 | Connects to the | |
|
| |
6 | SETUP Dipswitches | Dipswitches for setup of the unit (1, 2, 3 and 4 are for setting the |
|
| Machine #; 8 is for |
7 | FLASH Program Button | Push in6 for “Program” to upgrade to the latest Kramer firmware |
|
| (see section 7), or release for Normal (the factory default)7 |
8 | Power Connector with Fuse | AC connector enabling power supply to the unit |
1 For example, press ALL and then BRANCH button # 2 to connect BRANCH # 2 to all the LEAF devices 2 For example, press STO and then the LEAF button # 3 to store in Setup # 3
3 Only view, nothing is implemented at this stage
4 When in Confirm mode, the TAKE button illuminates
5 Also displays the firmware version number. Refer to section 6 .1 6 Using a screwdriver if required
7 Note that the FLASH PROG “Reset” button is located on the underside of the unit. Push in for “Reset”, or release for Normal (see section 7)
7
