Kyocera SE47 manual Setting an alert for roaming, Setting the roam ringer, Setting Call Guard

82-N8735-1.book Page 16 Thursday, October 27, 2005 12:37 PM

1.Select Menu → Settings → Network → Digital/Analog.

2.Select an option and press .

–Automatic automatically switches the phone between digital and analog.

–Analog only sets the phone to work in analog mode only.

–Analog call forces a call into analog mode for the duration of the next call.

–Digital only sets the phone to work in digital mode only.

Setting an alert for roaming

You may use this setting if you want the phone to alert you when you roam outside of your home service area.

1.Select Menu → Settings → Network → Roam/Svc Alert.

2.Select an option and press .

–When no svc alerts you with three tones decreasing in pitch when service is lost and three tones increasing in pitch when service is acquired again.

–On roam change alerts you with two decreasing tones when roaming service is acquired and three increasing tones when home area service is acquired again.

–On any change alerts you with three increasing tones if there is a change in roaming service or three decreasing tones if the phone loses service.

Setting the roam ringer

You can set a ringer to indicate when an incoming call will be subject to roaming charges.

•Select Menu → Settings → Sounds → Roam Ringer → Enabled.

Setting Call Guard

You can set the phone to warn you before you answer or place a call while roaming.

•Select Menu → Settings → Convenience → Call Guard → Call Prompt.

–The phone now emits a distinctive roam ring to indicate when you are roaming during calls.

–To accept or place a call while roaming,

you must press .

Note: Call Prompt is disabled when the phone is in Emergency Mode.

16 Making and Answering Calls