Kyocera SE47 manual Installing the battery, Charging the battery, Getting Started

82-N8735-1.book Page 1 Thursday, October 27, 2005 12:37 PM

1GETTING STARTED

Installing the battery

Your Kyocera KX5 phone comes with a removable lithium ion (LI Ion) battery. Fully charge the battery before using the phone.

To install the battery:

1.Hold the phone face

down.

2.Slide the tab at the bottom of the door up and remove the battery door.

3.Place the battery in the phone casing with the metal contacts facing

the right side of the phone.

4.Replace the battery

door by sliding the notches into the openings near the top of the phone.

5.Lower the battery door

and slide the tab at the bottom of the door up and then down to secure the cover into place.

Charging the battery

You must have at least a partial charge in the battery to make or receive calls.

To charge the battery:

1.Connect the AC adapter

to the jack on the bottom of the phone.

2. Plug the adapter into a

wall outlet.

The battery icon in the upper-right corner of the

screen tells you whether the phone is:

•Charging (the icon is animated)

•Partially charged

•Fully charged

Note: The battery will not charge if you use the phone while it is connected to an AC adapter.

Recharging the battery

You can safely recharge the battery at any time, even if it has a partial charge.

Note: To remove the battery, make sure the phone is powered off.

User Guide for the Kyocera Slider Remix KX5 Phone 1