compartment and checking the correct polarity insert 2 x AA IEC, LR6 1.5V batteries and replace the cover and rain cover
2)Base Station: Now open the battery cover at the back of the unit and checking the correct polarity insert 3 x AA IEC, LR6 1.5V batteries and replace the battery cover
Performing a function test and Setting time manually:
1.After powering up the units, the base station has to synchronize to the sensors before the weather data can be received.
2.Afterwards, the Weather Station will start receiving data from the transmitter. The outdoor temperature, humidity, windchill and wind speed should then be displayed on the Weather Station. If this does not happen after 30 seconds, the batteries will need to be removed from both units. You will have to start again from the beginning.
3.You may then check all cables for correct connection and all components for correct function by manually turning the
4.Time and date shall be manually set.
5.After the Weather Station has been checked for correct function with regard to the above points and found fit, the initial set up of the weather station system is finished and the mounting of the system components can take place. It must be ensured however that all components work properly together at their chosen mounting or standing locations. If e.g. there appear to be problems with the 915 MHz radio transmission, they can mostly be overcome by slightly changing the mounting locations.
4
