La Crosse Technology Mounting the WS-7394U-IT Wireless Weather Station, Using the Table Stand

a.With a nonabrasive solution, clean and dry the back of the mounting bracket and the mounting surface to ensure a secure hold. The mounting surface should be smooth and flat.

b.Remove the protective strip from one side of the tape.

c.Adhere the tape to the designated area on the back of the mounting bracket.

d.Remove the protective strip from the other side of the tape.

e.Position the remote temperature sensor in the desired location, ensuring that the Wireless Weather Station

can receive the signal.

Note: Mounting with adhesive tape is not recommended as a permanent mounting solution. Only use the adhesive tape during set-up process.

B.Mounting the WS-7394U-IT Wireless Weather Station

The Wireless Weather Station can be mounted in two ways:

•with the table stand

•on the wall with the use of a wall hanging screw (not included)

1.USING THE TABLE STAND

The indoor weather station comes with the table stand already mounted. If you wish to use the table-stand all that is required is to place the indoor weather station in an appropriate location.

2.WALL MOUNTING

a.Remove the table-stand. To do this, pull down on the stand from the rear and rotate forward.

b.Fix a screw (not included) into the desired wall, leaving approximately 3/16 of an inch (5mm) extended from the wall.

c.Place the indoor weather station onto the screw using the hanging hole on the backside.

d.Gently pull the indoor weather station down to lock the screw into place.

Maintenance and Care Instructions

A.Extreme temperatures, vibration, and shock should be avoided to prevent damage to the units.

B.Clean displays and units with a soft, damp cloth. Do not use solvents or scouring agents; they may mark the displays and casings.

C.Do not submerge in water.

19