DETAILED SET-UP GUIDE
I.BATTERY INSTALLATION (When one temperature sensor is being used)
1.First, insert the batteries to the temperature sensor (see “A. Remote Temperature Sensor” below).
2.Within 2 minutes of powering up the sensor, insert the batteries to the Weather Station (see “B. Wireless Weather Station” below). Once the batteries are in place, all segments of the LCD will light up briefly. Following the indoor temperature and humidity, and the time as 12:00 will be displayed. If they are not shown in LCD after 60 seconds, remove the batteries and wait for at least 60 seconds before reinserting them. Once the indoor data is displayed user may proceed to the next step.
3.After the batteries are inserted, the Weather Station will start receiving data signal from the sensor. The outdoor temperature should then be displayed on the Weather Station. If this does not happen after 2 minutes, the batteries will need to be removed from both units and reset from step 1 and the signal reception icon is no longer shown.
A. Remote Temperature Sensor |
| ||
1. | Remove the mounting bracket. The bracket snaps |
| |
| on and off easily. | Battery | |
2. | Remove the battery cover, by sliding the cover | ||
Cover | |||
| down. |
| |
3.Observing the correct polarity install 2 AA batteries. The batteries will fit tightly (to avoid
4.Replace the battery cover by sliding upwards. Be sure battery cover is on securely.
B. Wireless Weather Station
1.Remove the battery cover (the cover has white writing on it).
2.Observe the correct polarity, and install two Alkaline AA batteries.
3.Do not press any buttons for at least ten minutes. If a button is pressed before the indoor weather station has received information from the
4.Replace the battery cover.
5
