Samsung SND-7082 Lens Lens for the camera, Connect to the network, Body Bracket, Release Lock

Item		Description
Lens	Lens for the camera.
	ALARM IN	Used to connect the alarm input signal.
b Alarm I/O Port	ALARM OUT	Used to connect the alarm output signal.
	GND	Used for earth-grounding.
	The button restores all camera settings to the factory default.
	Press and hold for about 5 seconds to reboot the system.
c Reset Button	J If you reset the camera, the network settings will be adjusted so that
	DHCP can be enabled. If there is no DHCP server in the network, you
	must run the IP Installer program to change the basic network settings
	such as IP address, Subnet mask, Gateway, etc., before you can
	connect to the network.
Test Monitor Out	Output port for test monitoring the video output. Use the test monitor cable
	to connect to a mobile display and check the test video.
Focus Adjustment	The button adjusts the focus of image automatically.
Button
SD Memory Card	Compartment for the SD memory card.
Compartment
Lock Release Lever	Press the <UNLOCK> levers on both ends to separate camera module from
	the body.
Bracket	Used to install the camera on the wall or ceiling with the screws.
	If you drill a hole in the wiring cover for wiring,
Wiring Cover	remove the cover and attach the provided
	dustproof plate to it, and arrange the cables
	through the plate.
Release Lock	If you want to remove the bracket from the main unit or remove the camera
	from the bracket, push this out and turn the main unit in the <UNLOCK>
	direction.

● OVERVIEW

English _21