La Crosse Technology WS-8010U Weather Tendency Arrows, III. Adding More Sensors optional

although it is possible for the change to occur quickly. If the symbols do not change then the weather has not changed, or the change has been slow and gradual.

B.WEATHER TENDENCY ARROWS

There are 2 weather tendency arrows, one appearing on each side of the Weather Icons. One tendency arrow points up (on the left side of the Display) and one points down (on the right side of the Display). These arrows reflect current changes in the air pressure. An arrow pointing up indicates that the air pressure is increasing and the weather is expected to improve or remain fair, an arrow pointing down indicates that the air pressure is decreasing and the weather is expected to become worse or remain poor. No arrow means the pressure is stable.

III.ADDING MORE SENSORS (optional)

The WS-8010U can receive signals from up to three Sensors. The Sensor model(s) that you choose will come with their own set of instructions—follow those instructions for a complete guide to setting up. Following are some brief instructions for the basic set-up of additional sensors with the WS-8010U. Additional sensors can be purchased through the same dealer as this Weather Center, or by contacting La Crosse Technology directly (contact information can be found at the end of this manual). A TX4U will monitor temperature and humidity (it is the same model that comes with the WS-8010U), a TX3U will monitor temperature only, and the TX3UP monitors temperature via a 10 foot probe for use in pools, spas, etc. The TX3 units do not monitor humidity, thus when they transmit their information to the Weather Center dashes “- -” appear in the Humidity Display.

Note: When setting up multiple sensors it is important to remove the batteries from all existing units in operation, then to insert batteries first into all the sensors, and in numeric sequence. Second install batteries into the Weather Center. Transmission problems will arise if this is not done correctly and if the total time for set-up exceeds 6 minutes.

SET-UP OF MULTIPLE SENSORS

Note: The first sensor signal that the Weather Center receives is automatically assigned as the “boxed #1.” The 2nd to be received is the “boxed #2,” and the 3rd is the “boxed #3.”

1.It is necessary to remove the batteries from all units currently in operation.

2.Remove the battery covers to all sensor units (new and old).

3.Place all sensors in a numeric sequential order.

11