La Crosse Technology WS-8010U Mounting TX4U-REMOTE THERMO-HYGRO Sensor, Mounting with the Screws

MOUNTING

Note: Before permanently mounting ensure that the Weather Center is able to receive WWVB signals from the desired location. Extreme and sudden changes in temperature will decrease the accuracy of the Weather Center, and changes in elevation will result with inaccurate weather forecasting for the next 12 to 24 hours. These changes will require a 12 to 24 hour wait before obtaining reliable data. To achieve a true temperature reading, avoid mounting the TX4U—Remote Thermo-Hygro (or any sensor) where direct sunlight can reach the sensor. We recommend that you mount the sensor on a North-facing wall. The sending range is 80-ft (25m) however obstacles such as walls, concrete, and large metal objects can reduce the range. Place both units in their desired location, and wait approximately 15 minutes before permanently mounting to ensure that there is proper reception. The Weather Center should display a temperature in the OUTDOOR DISPLAY within 5 minutes of setting up. If the Weather Center loses the signal from the sensor, it will display the last temperature reading for 15 minutes. After 15 minutes of not receiving any signals the OUTDOOR DISPLAY of the Weather Center will display “- -.-”.

THE TX4U—REMOTE THERMO-HYGRO SENSOR

The TX4U—Remote Thermo-Hygro Sensor can be mounted in two ways:

•with the use of screws or,

•using the adhesive tape.

A. MOUNTING WITH THE SCREWS

1.Remove the mounting bracket/receptor from the packaging plastic.

2.Place the mounting bracket over the desired mounting surface. Through the 2 screw holes of the bracket, mark the mounting surface with a pencil.

3.Where marked, start the screw holes using the provided screws. Remove screws from the mounting surface.

4.Align the mounting bracket with the started screw holes.

5.Screw mounting bracket onto the mounting surface. The screws should be flush with the bracket.

15