6.Fit the mounting post (on the back of the sensor) into the receptor of the mounting bracket.
B.MOUNTING WITH ADHESIVE TAPE
1.With a nonabrasive solution, clean and dry the back of the mounting bracket and the mounting surface to ensure a secure hold. The mounting surface should be smooth and flat.
2.Remove the protective strip from one side of the tape. Press firmly onto the designated area on the back of the mounting bracket.
3.Remove the protective strip from the other side of the tape, and situate the mounting bracket. Firmly press the mounting bracket onto the mounting surface.
4.Fit the mounting post into the receptor of the mounting bracket.
II.THE WEATHER CENTER
1.Using a straightedge, horizontally mark 3 screw positions with a pencil. The screw positions should be spaced 3 5/8 of an inch (94mm).
2.Install 3 mounting screws (not included) into a wall within range, leaving approximately 3/16 of an inch (5mm) extended from the wall.
3.Place the Weather Center onto the screws, using the hanging holes on the backside. Gently pull the Weather Center down to lock the screws into place.
16
