La Crosse Technology WS-8300U A.Thermo-Hygrosensor, Remove the Protective Rain Cover

A.THERMO-HYGRO SENSOR

1.Remove the Protective Rain Cover.

2.Remove the Battery Cover.

3.Observing the correct polarity, install 2 “AA” Alkaline Batteries—make sure they do not spring free, or start-up problems may occur. Replace the Battery Cover.

Rain protection cover

Battery

Cover

Battery

Compartment

B. WIRELESS WEATHER STATION

Note: After the batteries are installed, DO NOT press any buttons. This may interfere with the signals, causing temperatures to register incorrectly.

1.Remove the Battery Cover on the back of the Wireless Weather Station.

2.Observing the correct polarity, install 2 “AA” Alkaline Batteries.

3.Replace Battery Cover.

4.Wait 15 minutes before pressing any buttons.

Battery Compartment

Battery

Cover

Sensor signal reception icon*

*When the signal is successfully received by the Weather Station, the icon will be switched on. (If not successful, the icon will not be shown in LCD) So the user can easily see whether the last reception was successful (icon on) or not (icon off). On the other hand, the short blinking of the icon shows that a reception is being done now.

C.SELECTING 12 OR 24 HOUR TIME DISPLAY

1.Press and hold the SET/CH button for about 5 seconds.

6