Land Pride 357-044M manual Refer to -9 & Figure, Table of Contents, Adjustments, Refer to Figure

Land Pride

Section 3: Adjustments

Table of Contents

Refer to Figure 3-8:

5.Set cutting height at 3 1/4” on the height indicator by placing the height adjusting stop in the 3” hole, and turning the height adjustment stop so that the flat side is against the stop handle.

6.Clamp the height adjusting stop against the stop handle. This will assure that the height will not move during the setting process. Otherwise, spring pressure from the deck lift springs will tend to pull the stop away from the handle.

Stop Handle

Height Adjusting Stop

23626

5/16”

Adjuster Bolt

Jam Nut

Adjuster

Hardware

23626

Deck Level Adjustment (Right Side Shown)

Figure 3-10

Cutting Height (Right Side Shown)

Figure 3-8

Refer to Figure 3-9& Figure 3-10.

Refer to Figure 3-11:

8.Loosen the two nuts on the front of height indicator so that the foot pedal is free.

7.On both sides of the mower, loosen all nuts on the deck lift threaded rods and hardware on the adjuster until all deck lift chains are loose and the deck is sitting tightly on all three blocks.

Nuts	Deck Lift
	Threaded Rod

Nuts

Foot

Pedal

Nut

Deck Lift

Block

Height

Indicator Rod

Nut

Deck Lift Chains

23626

Left Front

Deck Lift Chain

23690

Deck Level Adjustment (Right Side Shown)	Deck Lift Rod Adjustment (Left Side of Foot Pedal Shown)
Figure 3-9	Figure 3-11

2/27/07 Z44 & Z52 (S/N 472620 -526170) Zero Turning Radius Mowers Riding Mowers Accu-Z Razor® 357-044M 23