Land Pride 357-044M manual Preparation of Engine for Storage, New Season Preparation

Table of Contents

Section 4: Maintenance & Lubrication

Land Pride

Storage

Take the following steps when storing the mower at the end of the season and when the unit will not be used for long periods to ensure readiness for the next mowing season.

IMPORTANT: Do not use a high pressure washer on or around the IZT units. Water intrusion will result and void the IZT warranty.

1.Remove all grass, dirt, trash and grease that may have accumulated on the mower and moving parts.

2.Scrape off compacted dirt, trash and grass clippings from the deck underside. A coating of oil may also be applied to the deck underside to minimize oxidation.

3.Clean and touch up all scrapes with Land Pride spray paint.

4.Check blades and blade bolts for wear and replace if necessary.

5.Service air cleaner according to engine manufacture’s recommendations.

6.Check thoroughly for any worn or damaged parts that need replacing and order them from your nearest Land Pride Dealer.

7.Thoroughly lubricate machine, according to lubrication instructions.

8.Block mower up so weight is off tires.

NOTE: Do not deflate tires.

9.Protect battery from freezing temperatures. Disconnect the negative ground wire from the battery to reduce the chances of a slow electrical drain. Occasionally recharging battery during storage will extend battery life.

10.Prepare engine for storage as described below.

11.Store mower in a clean, dry place.

Preparation of Engine for Storage

When engine is to be unused for long periods, proceed as follows:

1.Run engine for a minimum of 15 minutes.

2.Drain oil from crankcase while engine is still warm.

3.Refill with fresh oil of proper viscosity.

4.Drain fuel tank and run engine until it stops from lack of fuel. Gasoline evaporates if left in carburetor for long periods, forming gum and varnish deposits in carburetor. These deposits will cause engine flooding and loss of power.

5.Remove and replace fuel filter if not done in previous 100 hours.

6.Remove spark plugs and pour a tablespoon of engine oil into each spark plug hole. Install plugs, but do not reconnect plug leads.

7.Crank engine with starter at least a dozen revolutions to distribute oil over cylinder walls and valve mechanism.

8.Clean exterior surface of engine. Spread a light film of oil over any exposed metal surfaces of engine that are subject to corrosion.

9.Clean dirt and chaff from cylinders and fins, blower housing and muffler.

10.Check oil filler cap and fuel tank cap to make certain they are securely in place.

New Season Preparation

Before starting the mower following post season storage, the following servicing is required:

IMPORTANT: Do not use a high pressure washer on or around the IZT units. Water intrusion will result and void the IZT warranty.

1.Clean mower, removing trash and dirt accumulation.

2.Check engine oil level.

3.Tighten any bolts that have loosened and make sure all hair pins, cotter pins and clevis pins are in place.

4.Install all safety shields and review safety precautions listed in this manual.

5.Check and inflate tires to 8-12 psi.

6.Fill fuel tank with fresh gasoline.

7.Reconnect spark plug leads to spark plug.

8.Run machine at half speed for 5 minutes, checking operation of the control levers. Stop engine and check for oil leaks, loose fittings and so forth.

36 Z44 & Z52 (S/N 472620 -526170) Zero Turning Radius Mowers Riding Mowers Accu-Z Razor® 357-044M 2/27/07