Land Pride 357-044M manual Hydraulic System, Hydraulic oil and Filter, Refer to Refer to Figure

Table of Contents

Section 4: Maintenance & Lubrication

Refer to Figure 4-4:	!	WARNING
Remove the cover over the fuse to access the fuse.

Land Pride

Uncovered

20 Amp Fuse

23809

20amp Fuse W/Cover Removed

Figure 4-4

Before attempting any diagnosis of electrical system, use a test light or voltmeter to check battery voltage. If battery voltage is satisfactory, check cleanliness and tightness of terminals and ground connections. A general understanding of electrical servicing and use of basic test equipment is necessary for troubleshooting and repair.

Always wear adequate eye protection when servicing the hydraulic system and battery.

Hydraulic System

The Razor is equipped with Hydro-Gear IZT (Integrated Zero-Turn Transaxle) units. These units are self contained, except for changing oil and filters. Repair of an IZT unit should be performed by trained technicians only.

NOTE: The IZT units are equipped with bypass valves. For more information refer to “Moving Mower with Stalled Engine” on page 15.

IMPORTANT: Do not use a high pressure washer on or around the IZT units. Water intrusion will result and void the IZT warranty.

Hydraulic oil and Filter

Major overhaul or repair of starting motor or alternator should be performed by trained technicians only.

Access to IZT Units

(Integrated Zero-Turn Transaxle)

Refer to Refer to Figure 4-5

The IZT units are accessed by lifting the seat platform which is hinged at the front. To raise it, remove two bolts and tilt the seat platform up and forward.

NOTE: If the seat is equipped with the optional arm rest kit, make certain to place the control arms in the park position, set park lever to (ON) and pivot the arm rests upward before tilting the seat platform.

Bolts

23643

Access to IZT Units

Figure 4-5

Refer to Figure 4-6:

Initially change hydraulic oil and oil filter after the first 50 hours of operation. Thereafter, change the hydraulic oil and oil filter every 200 hours or every 2 years whichever comes first. Filter replacement kit #356-552A may be purchased from your nearest Land Pride dealer. The Kit contains two filters and two magnetic plugs.

Change hydraulic oil and oil filter as follows:

1.Raise mower so that filter and 9/16” magnetic plug can be accessed and worked on in a safe manner.

2.Place oil pan beneath pump.

Magnetic Plug

Oil Filter

23692

Access to Oil Filter and Magnetic Plug

Figure 4-6

30 Z44 & Z52 (S/N 472620 -526170) Zero Turning Radius Mowers Riding Mowers Accu-Z Razor® 357-044M 2/27/07