Table of Contents
Section 6: Maintenance
High Altitude Carburetor Kit
IMPORTANT: The
Gondo vehicles shipped from the factory are equipped with carburetors designed to operate efficiently between 0 and 4,999 feet. Carburetor change over kits for different altitudes may be purchased from your nearest Land Pride Dealer. The following kits are available:
Elevation | Carburetor Kit No. |
0’ - 7,999’ | Engine Standard |
8,000’ & up |
Power Steering Shield
21346
Figure
Refer to Figure
5. Remove bolts securing belt cover and remove cover.
Power Steering Belt
Refer to Figure 6-5 & Figure 6-6
Power steering belt and pump are positioned behind the engine and are protected by a shield. Do not remove shield except to service the belt and always replace shield after servicing the belt.
Replace power steering belt when it shows signs of severe cuts, tears, excessive weather checking and cracking or burns caused by slipping. Slight raveling of belt covering does not indicate failure. Trim ravelings with a sharp knife.
Inspect belt pulley grooves and flanges for wear. A new belt, or one in good condition, should never run against bottom of pulley groove. Replace pulley when this is the case, otherwise belt will lose power and slip excessively.
Never pry a belt to get it on a pulley as this will cut or damage the fibers of the belt covering.
Keep oil and grease away from belts and never use belt dressings. Any of these will destroy the belt composition in a very short time.
!CAUTION
Make certain to keep fingers from getting caught between belt and pulley when rotating belt over pulley.
Replace power steering belt as follows:
1.Prepare vehicle for maintenance as outlined in steps
2.Safely secure the seat console in the raised position.
3.Disconnect negative battery cable.
4.Safely secure cargo box and seat console in the up position to prevent injury.
Drive Pulley |
Driven Pulley
Power Steering
Pump
21353
Figure
Refer to Figure
6.Loosen belt
7.Remove belt by rolling it off over the drive pulley and then lifting it up off the driven pulley.
8.Reinstall new belt by placing it over the driven pulley and then rolling it over the drive pulley.
9.
10.Reinstall belt cover and fasteners.
11.Reconnect battery negative cable.
12.Remove blocks securing cargo box up and lower cargo box.
6/30/05 | 4400EX Heavy Duty Off Road Utility Vehicle |