Table of Contents
Land Pride
Section 1 Assembly and Setup
Section 1 Assembly and Setup
Tractor Requirements | 3. Mount the upper hitch bars (#1), to the front hitch | ||
This mower is designed with a | plates on the mower frame using the 5/8" x 1 3/4" long | ||
Horse power rating of tractor should not exceed 26 PTO | bolts (#11), lock washers (#12) and hex nuts (#13). | ||
horse power. | 4. Remove the 5/8" x 5" long bolt (#5), lock washer (#6), | ||
| ! CAUTION | and hex nut (#7) from the upper pivoting hitch | |
| subassembly. | ||
| 5. Swing the upper hitch bars (#1) up to a vertical | ||
Do not over speed PTO or machine damage may result. | |||
|
|
| position. Raise the upper hitch braces (#2) up inside |
| NOTE: In order to maintain steering control, ballast |
| the upper hitch bars as shown. |
|
| 6. Assemble the upper pivoting hitch (#3), spacer top | |
| may have to be added to your tractor front end. To |
| |
| determine whether or not to add ballast, refer to your |
| hitch (#4), 5/8" x 5" long bolt (#5), lock washer (#6), |
| tractor operator’s manual. |
| and hex nut (#7). |
|
|
| 7. Place the chute (#14) over the square holes on the |
|
|
| |
Upper Hitch Arms Assembly | right hand side of the deck. Insert the 5/16" carriage | ||
bolts (#15) from the underneath side of the deck. | |||
Refer to Figure | Secure with the 5/16" nuts (#16) lock washers (#17) | ||
1. Remove the upper hitch bars (#1), upper hitch braces | and flat washers (#18). | ||
| (#2), and upper pivoting hitch subassembly (#3) |
| |
| through (#7) from storage position on top of mower |
| |
| deck. |
| |
2. Bolt the upper hitch braces to the mounting tabs on |
| ||
| back of the deck using 1/2" x 1 1/2" long bolts (#8), |
| |
| lock washer (#9), and hex nut (#10). |
|
Figure | 15033 |
8 | FD1548 & FD1560 | 7/18/08 |