Table of Contents
Section 1: Assembly &
Land Pride
Gauge Wheel Model Set-up
Refer to Figure
The deck with gauge wheels is shipped from the factory completely assembled to the parallel arm with the exception of installing the rear ratchet jack and one gauge wheel.
Ratchet Jack Installation
1.Check 5/8" hex flange lock nuts attached to bolts (#3). They should be drawn up snug, not tight.
2.Cut ties securing
3.Install ratchet jack (#8) to cutter deck with 1" dia. clevis pin (#6). Secure with hair pin (#3).
4.Attach opposite end of ratchet jack to
Gauge Wheel Installation
1.Install 1 1/4" I.D. machine washer (#4) over yoke spindle (#1) as shown.
2.Insert yoke spindle (#1) into the front support frame.
3.Install second 1 1/4" I.D. machine washer (#4) over yoke spindle (#1).
4.Secure yoke spindle to frame with 5/16" dia. roll pin (#7).
24617
Gauge Wheel
Figure
24 RCP2660, RCPM2660, RCP3060 and RCPM3060 Parallel Arm Rotary Cutter | 12/16/08 |