![Section 5: Hydraulic Plumbing](/images/new-backgrounds/88989/8898967x1.webp)
Table of Contents
Section 5: Hydraulic Plumbing
Hydraulic Plumbing Without Solenoid
Refer to Figure
The standard Parallel Arm Cutter is equipped with three
(3) remote cylinders to operate the parallel arms and
deck. These cylinders are connected directly to the tractor's remote duplex outlets and are controlled by tractor operator. Each cylinder requires a duplex outlet at the tractor.
22034
Remote Cylinder Plumbing without Solenoid Control box
Figure
Hydraulic Plumbing With Solenoid
Refer to Figure 2-1 on page 25 and Figure 5-2 on this page.
IMPORTANT: The flow control valve must be plumbed correctly. See “Tractors Rated at 15 GPM and Under” on page 16 and “Tractors Rated at 16 GPM and Above” on page 16.
The solenoid controlled cylinders provide for momentary push button switch operation of each cylinder. These cylinders are connected directly to the solenoid control box. Two hydraulic hoses are connected directly to one of the tractor’s remote duplex outlets. The hydraulic cylinders are then controlled by an electrical control stick with push button switches on the tractor near the operator.
Flow
Control
Valve
The flow control valve must be plumbed correctly.
22035See “Tractors Rated at 15 GPM and Under” on page 16 and “Tractors Rated at 16 GPM and Above” on page 16.
Solenoid Control Box
Remote Plumbing with Solenoid Control box
Figure
32 RCP2660, RCPM2660, RCP3060 and RCPM3060 Parallel Arm Rotary Cutter | 12/16/08 |