Updating Software
K - 8
hardware address, and download path and filename to the appropriate host file (usually /etc/
bootptab).
Some BOOTP and TFTP implementations require a specific directory for the EPS.SYS file; in
this case the path should not be specified in the bootptab file and the file must be placed in that
directory. See your host’s documentation for instructions on how to configure the EPS.SYS file in
the directory.
If BOOTP cannot be used to configure the Server's IP parameters, configure them by hand using
the following commands listed below.
NOTE: For instructions on how to log into the Server and enter these commands,
refer to Chapter 6, TCP/IP Configuration.
Local> SET PRIVILEGED
Password> SYSTEM (not echoed)
Local>> DEFINE SERVER IPADDRESS nnn.nnn.nnn.nnn
Local>> DEFINE SERVER SOFTWARE "/tftpboot/
EPS.SYS"
Local>> DEFINE SERVER LOADHOST nnn.nnn.nnn.nnn
Local>> LIST SERVER BOOT
Local>> INITIALIZE RELOAD