Lathem 800P manual Quick Easy Setup Wall Mount, Step

800P TruAlign Time Recorder User Guide

Quick Easy Setup (Wall Mount)

To setup your 800P, follow these next steps:

Step 1

Separate the back-plate from the 800P by removing the Philips head screw. Retain the screw for later.

Step 2

Install the wall-mount bracket to the wall using the supplied wall-mount screws. Note: For best visibility mount the 800P about 48 inches from the floor.

48inches

Step 3

Using the supplied 8-32 x ¼ Philips head screws install the back-plate to the wall-mount bracket.

Step 5

Align and place the 800P on the back-plate and secure the two together with the 8-32 x ¼ Philip head screw. Be careful not to pinch the AC cord.

Note: Make sure the bottom of the timecard shelf is over the edge of the back-plate before securing the screw.

Step 4

With the back-plate secured to the wall-mount bracket, plug the AC wall adapter into the 800P.

Note: The time, date and other settings are factory set. See “Factory Settings” below. If these settings are acceptable you are ready to begin, otherwise see Page 11 “Programming the 800P”.

Factory Settings

￿ Time=U.S. Eastern Time ￿ Daylight Savings=On

￿ Spring Daylight Savings=Second

Sunday in March

￿ Fall Daylight Savings=First

Sunday in November

￿ Displayed Time Format=AM/PM

hours & Minutes

￿ Printed Time Format=AM/PM

hours & Minutes

￿ Day of Week Language=English ￿ Confirmation Beep=Disabled

Page 8