Lennox Hearth STOP, B. BEFORE OPERATING, LIGHTING INSTRUCTIONS, WHAT TO DO IF YOU SMELL GAS, TO TURN OFF GAS TO APPLIANCE, FOR YOUR SAFETY READ BEFORE LIGHTING

LIGHTING INSTRUCTIONS – MILLIVOLT GAS VALVE

FOR YOUR SAFETY READ BEFORE LIGHTING

WARNING: IF YOU DO NOT FOLLOW THESE INSTRUCTIONS EXACTLY, A FIRE OR EXPLOSION MAY

RESULT CAUSING PROPERTY DAMAGE, PERSONAL INJURY OR LOSS OF LIFE.

A. This appliance has a pilot which must be lighted with a piezo	• Do not use any phone in your building.
ignitor. When lighting the pilot, follow these instructions	• Immediately call your gas supplier from a neighbor’s phone.
exactly.
	• If your gas supplier cannot be reached, call the fire depart-
B. BEFORE OPERATING smell all around the appliance area for	ment.
gas. Be sure to smell next to the floor because some gas is	C. Use only your hand to push in or turn the gas control knob.
heavier than air and will settle on the floor.
	Never use tools. If the knob will not push in or turn by hand,
WHAT TO DO IF YOU SMELL GAS	do not try to repair it, call a qualified service technician.
	Force or attempted repair may result in a fire or an explosion.

•Extinguish any open flame.

•	Open windows.	D. Do not use this appliance if any part has been under water.
		Immediately call a qualified service technician to inspect the
•	Do not light any appliance.
		appliance and to replace any part of the control system and
•	Do not touch any electrical switches.	any gas control which has been under water.

LIGHTING INSTRUCTIONS

1.STOP! Read the safety information above on this page. 6. Wait five (5) minutes to clear out any gas. If you then smell gas,

					STOP! Follow “B” in the safety information above on this page. If you
2. Access the lower control compartment.					do not smell gas, go to the next step.
3. Turn remote wall switch to “OFF.”				7.	Push in gas control knob slightly and turn counterclockwise
4. Verify main line shut-off valve is open.					to “PILOT.”
				8.	Push in control knob all the way and hold in. Immediately light the
5. Push in gas control knob slightly and turn clockwise					pilot by triggering the spark ignitor (pushing the button) until pilot
	to “OFF.”				lights. Continue to hold the control knob in for about 1 ¹⁄₂ minutes
					after the pilot is lit. Release knob and it will pop back up. Pilot should
					remain lit. If it goes out, repeat steps 5 through 8.
		OUT	IN		• If knob does not pop up when released,
TPTH					stop and immediately call your service
TP	I H				technician or gas supplier.
		OFF
			P		• If pilot will not stay lit after several
TH	L OW	it
			O
			I
			L
		NO	T		tries, turn the control knob to “OFF”
					and call your service technician or
	TOLI
	P
					gas supplier.
				9.	Turn gas control knob counterclockwise
Note: Knob cannot be turned from “PILOT” to “OFF”					to “ON.”
unless the knob is pushed in slightly. Do not force.				10.	Close lower control compartment.

TO TURN OFF GAS TO APPLIANCE

1.	Turn remote wall switch “OFF.” The pilot will remain lit for	4.	Depress gas control knob slightly and turn clockwise
	normal service.		to “OFF.” Do not force.
2.	For complete shutdown, turn remote wall switch to “OFF.”	5.	Close lower control compartment.

3.Access the lower control compartment.

16