Lennox Hearth LSM40ST-N-PV Indicator Icons, Receiver, Figure, Remote Transmitter

LENNOX HEARTH PRODUCTS • MONTEBELLO® SEE-THROUGH POWER VENT DV GAS FIREPLACES (LSM40ST-N-PV) • CARE AND OPERATION INSTRUCTIONS

Key Lock

This function will lock the keys to prevent

unsupervised­operation. To activate this func- tion, press the MODE and UP keys at the same time. To deactivate this function, press the MODE and UP keys at the same time.

Manual Bypass of the Remote System

If the batteries of the Receiver or Transmitter are low or depleted, the appliance can be turned on manually by sliding the three position slider switch to the ON position. This will bypass the remote control feature of the system and the appliance main burner will come on if the gas valve is in the "ON" position.

Three-Position Slider Switch (in REMOTE position)

On

Remote

Transmission		Child Safety Lock-Out
		Low Battery Alarm
		Room Temperature
Set Point
Temp./Level/State
Flame On	Maximum Level Indicatiors
Figure 6: Indicator Icons

Off

PRG

Figure 4: Receiver

Flame Level 5

Figure 7

POWER VENT APPLIANCE OPERATING INSTRUCTIONS

To turn ON the Appliance:

Flame Level Maximum

Figure 8

		WARNING
		Will	Cause
Hot	Fireplace		to
		Burns
Severe		ChildrenFire-
Never		Allow orother
		Glass
TouchParts
place

UP/DOWN

Arrow Key

MODE Key

Blue LCD Display

ON/OFF Key

ROOM

TEMPERATURE

Key

Using the Receiver: Manually slide the three-position slider to the "ON" position.

Using the Remote Transmitter: Manually slide the three-position slider on the Re- ceiver to the "ON" position, and then press the ON/OFF key on the Remote Transmitter.

The blower should start immediately. The igniter will start sparking, and then the pilot will light. After a few seconds, the burner should light.

To turn OFF the Appliance:

10

Figure 5: Remote Transmitter

Using the Receiver: Manually slide the three-position slider to the "OFF" position.

Using the Remote Transmitter: Press the ON/OFF key.

The burner and pilot should turn off immedi- ately. The blower will continue to run for about 90 seconds and then stop.

NOTE: DIAGRAMS & ILLUSTRATIONS ARE NOT TO SCALE.