Lennox Hearth PB42 manual Using the Batteries, Installing the Batteries, To install the batteries

Using the Batteries

The PB42 uses lithium-ion 2400 mAh batteries

(Model 318-015-001) for power. You can operate the PB42 with one or two batteries installed. You must fully charge the batteries before you can use the PB42. Fully charged batteries can last for up to one week without needing to be recharged.

Use Intermec battery pack model 318-015-001 only. Use of another pack may present a risk of fire or explosion.

The battery pack used in this device may present a fire or chemical burn hazard if mistreated. Do not disassemble, heat above 100°C (212°F), or incinerate.

Dispose of used battery packs promptly. Keep away from children.

Installing the Batteries

Make sure you fully charge the batteries before you use your PB42. You can charge the batteries before or after you install them into the PB42. You can use only one battery to power the PB42, but you may experience reduced performance.

To install the batteries

1Pull and hold the battery cover latch firmly toward the front of the printer and lift up on the battery cover.

Battery cover

Battery cover latch

16 PB42 Portable Receipt Printer User’s Guide