Lennox Hearth VIN operation manual Baffle and Log Set Installation, Log Set and Embers

INSTALLATION

Baffle and Log Set Installation

Baffle

The cast iron baffle is wrapped in foam and shipped between the outside of the firebox and the outer shell of the stove. Remove the foam and install the baffle in the rectangular hole in the top of the firebox. The baffle rests unsecured in the hole.

Figure 10

Log Set and Embers

	Firebox Accessories / Parts
Cat. No.		Description
H5861		Log Set
H5863		Bag of Embers (volcanic stone)
H5864		Bag of Rockwool (glowing embers)
H5865		Bag of Steel Wool

Log Installation Instructions

If logs are not installed according to the log installation instruc- tions, flame impingement and improper combustion could occur and result in soot and/or excessive production of carbon monoxide (CO), a colorless, odorless, toxic gas.

The size and position of the log set is critical to achieve a safe, reliable and attractive flame pattern. Any attempt to use a differ- ent log set in the fireplace will void the warranty and will result in incomplete combustion, sooting and poor flame quality.

Parts list: rear log, left front log, right front log and straight twig

1)Remove the logs from the box and carefully unwrap them. The logs are fragile so handle them with care.

2)Align the holes in the bottom of the rear log (the longest log in the set) with the two pegs just to the rear of the rear burner tube and slide the log down onto the pegs (Figure 10). The charred black surface of the log should face the front.

3)The left front log has two pegs protruding from the top surface (Figure 11). The charred black with white highlights surface of the log should be facing forward. Slide this log down onto the left front and center front pegs.

4)The right front log (positioned with the black charred surface towards the front) should be placed on the peg protruding from the right end of the left front log and the remaining peg at the right end of the metal log support panel (Figure 11).

5)The remaining straight twig has two holes in the bottom. Position the twig so the black and white charring is to the front and slide the holes over the peg in the left front log and the peg in the rear log (Figure 12). It may be necessary to roll the top of the rear log slightly forward to put this twig on the pegs.

6)Figure 13 shows the entire log set assembled. The embers provided may be placed one high in front of the front burner tube using care not to cover all the burner ports. Any extra embers may be placed at the ends of the front log, off the burner. Place small pinches of rockwool on top of the embers.

Figure 11

Figure 12

Embers

Pilot Viewing

Figure 13

Note the location of the hole for viewing the pilot light. When the pilot is burning, a blue flame can be seen through

this hole.