vConnect all power cords to a properly wired and grounded electrical
outlet.
vConnect to properly wired outlets any equipment that will be attached to
this product.
vWhen possible, use one hand only to connect or disconnect signal cables.
vNever turn on any equipment when there is evidence of fire, water,or
structural damage.
vDisconnect the attached power cords, telecommunications systems,
networks, and modems before you open the device covers, unless
instructed otherwise in the installation and configuration procedures.
vConnect and disconnect cables as described in the following table when
installing, moving, or opening covers on this product or attached devices.
Toconnect:
1. Turneverything OFF.
2. First, attach all cables to devices.
3. Attach signal cables to connectors.
4. Attach power cords to outlet.
5. Turndevice ON.
Todisconnect:
1. Turneverything OFF.
2. First, remove power cordsfrom outlet.
3. Remove signal cables from connectors.
4. Remove all cables from devices.
Lithium battery notice
CAUTION:
Danger of explosion if battery is incorrectly replaced.
When replacing the lithium coin cell battery,use only the same or an
equivalent type that is recommended by the manufacturer.The battery contains
lithium and can explode if not properly used, handled, or disposed of.
Do not:
vThrow or immerse into water
vHeat to more than 100°C (212°F)
vRepair or disassemble
Dispose of the battery as required by local ordinances or regulations.
The following statement applies to users in the state of California, U.S.A.
Perchlorate material: Special handling may apply.Go to:
http://www.dtsc.ca.gov/hazardouswaste/perchlorate
Chapter1. Important safety information 9