Lenovo 8089, 8094, 8088, 8090, 8087, 8086 manual Removing and replacing a hard disk drive

Removing and replacing a hard disk drive

1.Open the cover. See “Opening the cover” on page 90.

2.Pivot the drive bay assembly upward to gain access to the hard disk drive.

3.Disconnect the signal and power cables from the rear of the hard disk drive.

4.Lift the hard disk drive and bracket up to remove it from the drive bay.

5.Note the orientation of the hard disk drive in the plastic bracket.

6.Remove the drive by flexing the plastic enough to slide the drive out.

7.Install the hard disk drive into the plastic bracket by flexing the plastic enough to slide the drive in.

8.Install the hard disk drive and bracket into the bay until it snaps into position.

9.Reconnect the signal and power cables to the rear of the hard disk drive.

Chapter 8. Replacing FRUs 103