Lenovo X230I manual Startup menu, Changing the startup sequence

Table 6. Security menu items (continued)

Menu item	Submenu item	Value		Comments
Anti-Theft	Intel AT Module	•	Disabled	Enable or disable the UEFI BIOS interface to
	Activation	•	Enabled	activate the Intel AT module, which is an optional
				anti-theft service from Intel.
		•	Permanently
			Disabled	Note: If you set the Intel AT module activation
				to Permanently Disabled, you will be unable to
				enable this setting again.
	Intel AT Suspend	•	Enter	This option is displayed only when the anti-theft
				function is activated.
				The Intel anti-theft suspend screen will be
				displayed at next boot to enter the suspend
				mode.
	Computrace Module	•	Disabled	Enable or disable the UEFI BIOS interface to
	Activation	•	Enabled	activate the computrace module. Computrace
				is an optional monitoring service from Absolute
		•	Permanently
				Software.
			Disabled
				Note: If you set the computrace module
				activation to Permanently Disabled, you will be
				unable to enable this setting again.

Startup menu

To change the computer startup settings,, select Startup from the ThinkPad Setup main menu.

Attention:

•After you change your startup sequence, you must be extremely careful not to specify a wrong device during a copy, a save, or a format operation. If you specify a wrong device, your data and programs might be erased or overwritten.

•If you are using the BitLocker drive encryption, you should not change the startup sequence. BitLocker drive encryption detects the change of startup sequence and locks the computer from booting.

Changing the startup sequence

To change the startup sequence, do the following:

1.Select Boot or Network, then press Enter. The default boot list is displayed, showing the order in which devices will be started up. Even devices that are not attached to or installed on your computer are listed.

•Use the Boot submenu to specify the startup sequence that runs when you turn on the power.

•Use the Network submenu to specify the startup sequence that runs when Wake on LAN is enabled. Wake on LAN is commonly used by LAN administrators in corporate networks to get remote access to your computer.

2.Set the startup sequence by using the following keys:

•Use cursor keys to select a device.

•Use F6 or the combination of Shift and + to move the device up to a higher priority.

•Use F5 or – to move the device down to a lower priority.

•Use the combination of Shift and ! to exclude or include a device.

3.Press F10 to save the changes and restart the system.

Chapter 8. Advanced configuration 119