Chapter 4. Troubleshooting
Troubleshooting
If you do not find your problem here, see Chapter 1. The following section only describes problems that might negate the need to refer to the more comprehensive information in Chapter 1.
Display problems
When I turn on the computer, nothing appears on the screen.
•If the screen is blank, make sure that:
-The AC power adapter is connected to the computer, and the power cord is plugged into a working electrical outlet.
-The computer power is on. (Press the Power button again for confirmation.)
•If these items are properly set, and the screen remains blank, have the computer serviced.
When I turn on the computer, | • Restore | |
only a white cursor appears on | the entire contents of your hard disk to its original factory | |
a blank screen. | contents using the Lenovo OneKey Recovery System. If you | |
| still see only the cursor on the screen, have the computer | |
| serviced. |
|
The screen goes blank while | • Your power management is enabled. Do one of the | |
the computer is on. | following to resume from sleep or hibernation mode: | |
| - Press any key on the keyboard. (Notebook mode only) | |
| - Press the Power button. | |
| - Press the Windows button. | |
| - Press F9 ( | ) to confirm whether the backlight of the |
| LCD screen has been turned off. | |
Sleep or hibernation problems
The critical
The computer enters sleep mode immediately after Power-on.
•The battery power is getting low. Connect the AC power adapter to the computer.
•Make sure that:
-The battery is charged.
-The operating temperature is within the acceptable range. See “Chapter 2. Use and care Information” in the Lenovo Safety and General Information Guide.
Note: If the battery is charged and the temperature is within range, have the computer serviced.
28
