HANDLING A DISCCD OPERATION

Although built to withstand a certain amount of the effects from dust, soil and scratches, discs should be treated with care normally accorded to conventional analog discs (records). Always protect a disc against scratches, soil and dust etc. We recommend that during non-use periods, the discs should be stored in their original cases.

Since any dirt, scratches or warping of the disc can cause skipping or intermittent sound or noise, bear in mind the following points:

When holding the discs, take care not to touch the playing

HANDLE DISC AS SHOWN

surface.

 

 

 

 

 

 

 

 

 

 

 

 

Store the discs in their cases. Return them to their cases

 

with the label surface facing up and push down lightly on

the label surface.

 

 

 

 

 

 

 

 

 

 

 

 

Do not place discs near a heating device or a place where

the temperature is high or in dusty areas.

 

 

 

 

 

 

 

 

 

 

 

 

Do not write on the label surface using a ballpoint pen and

do no stick labels on the CD.

 

 

 

 

 

 

 

 

 

 

 

 

Wipe away any fingerprints or dust on the playing surface

 

of a disc using a soft cloth.

 

 

 

 

 

 

 

 

 

 

 

 

Bear in mind the following points when cleaning your discs:

- Always wipe from the inside toward the outside of the disc.

- Never in a circular motion.

 

 

 

 

 

 

 

 

 

 

 

 

- Do not use conventional record cleaners, anti-static agents,

CLEAN FROM CENTER TO EDGE

benzene, thinner or other solvents.

 

 

 

 

 

 

 

 

 

 

 

 

PLAYING A CD (COMPACT DISC)

 

 

 

 

 

 

 

 

 

 

 

 

This set is designed to play only compact discs bearing this identification logo

 

 

 

 

 

 

 

 

 

 

 

 

(logo

must say DIGITAL AUDIO).

 

 

 

 

 

 

 

 

 

 

 

 

1.Press the Power Switch ON, the Power/Batt. Lamp will light.

2.Press the CD Switch, the CD Indicator Lamp will light.

3.Press the CD Door Open Button (near the door) to open the CD door.

4.Insert a CD with the LABEL side facing UP, close the CD Door gently by pushing

it down.

” and then

 

 

 

 

 

 

 

 

 

 

5. The Display will show 6 zeros “

 

 

TRACK

 

 

the total number of tracks (songs) and the total play

 

 

 

 

 

time of the disc. (If the disc is upside down or

 

 

 

 

 

 

 

 

 

damaged, the Display will show 6 zeros “

”, and then “

” will be

flashing).

 

 

 

 

 

 

6.To start the music, press the CD Play/PauseINTRO PROGRAMButton (wait a few seconds for music

to start). The first track number “ ” will appear in the Display, and the disc will start playing. The played time shows in the Display also.

7.Adjust the Volume Control to your taste. For extra bass sound, slide the Bass

Boost Switch ON.

 

 

 

 

8. To pause the music - if the phone rings or other reasons,

 

 

TRACK

press the CD Play/Pause Button, the elapsed play time

 

 

 

will flash to remind you that you are in pause mode.

 

 

 

 

 

9.To resume the music from pause, press the CD Play/Pause Button again. The track number will be steady on (not flashing).

10.To stop playing music, press the CD Stop Button.

11.To shut the power off, press the Power Switch again, and the Power/Batt. Lamp will go off.

9

CD-160S050699 V.2

E

 

Page 10
Image 10
Lenoxx Electronics CD-160 manual Handling a Disccd Operation, Playing a CD Compact Disc