Lenoxx Electronics CD-160 manual Radio Operation, To Play The Radio

CD-160S050699 V.2 E

RADIO OPERATION

TO PLAY THE RADIO

Make sure the speakers are connected (speaker wires plugged into the jacks in the back of the set).

1.Press the Power Switch ON (the Power Lamp will light).

2.Press the Radio Switch ON (the Radio Indicator will light).

3.Press the AM/FM Band Switch to select the desired wave band.

4.Tune to desired station by pressing the Tuning or Button. Each time the button is pressed, the frequency changes.

5.To search for a station quickly (automatic tuning), keep the Tuning or Button pressed until the station starts to change rapidly, then release the Button and it will stop

	at the next strong station.
6.	If you tune into a FM stereo station, “	” will
	show in the Display.
7.	Adjust the Volume Control to your listening preference.

8.If you prefer more bass, slide the Bass Boost Switch to ON position.

9.To turn off the radio, press the Power Switch again, the Power Lamp will go off.

PRESETTING STATIONS

UP TO 10 AM AND 10 FM STATIONS CAN BE STORED INTO THE PRESET MEMORIES. (THEY WILL REMAIN IN MEMORY AS LONG AS THE BATTERIES ARE INSTALLED, OR AC POWER CORD IS CONNECTED.)

1 . Press the Band Switch to select AM or FM band, and
			PRESET	PROGRAM
press the Tuning	or	Button to select a station.
2. Press the Radio Store (Program) Button, “ PROGRAM ”
will flash in the Display.

3.While the “ PROGRAM ” is blinking, press the Radio Presets Button to choose a memory location (01-10). (Example: Push the Radio Presets Button 3 times for Preset Number 3; 4 times for Preset Number 4.)

4.Press the Radio Store (Program) Button again to confirm. The station now broadcasting is stored into that preset memory.

NOTE: Steps 2-4 should be done quickly.

5.Repeat the above steps 1 to 4 to store other 9 stations into memory.

6.Each memory location (01-10) can store 2 stations, one for AM, the other for FM.

N O T E : Before you disconnect the power (AC and Battery) of the set, make sure the Power Switch is OFF, then you have approximately 30 seconds to re-connect the power. Otherwise, the memories may be lost and need to be re-programmed.

TO LISTEN TO PRESET MEMORY STATIONS (after you programmed them)

1.Press the Power Switch ON, the Power/Batt. Lamp will light.

2.Press the Radio Switch, the Radio Indicator will light.

3.Press the Band Switch to select the band you want (AM or FM).

4.Press the Radio Presets Button to select the stations stored (01-10). You will receive the station you stored into that preset memory. Pressing the button several times will give you the different preset stations you stored into the preset memories 1 to 10 (Example: Pressing the button 3 times will give you Preset Number 3, press the button 4 times will give you Preset Number 4). Word “ PRESET ” and Preset Number will show in the Display.

5.To shut off the radio, press the Power Switch again, the Power/Batt. Lamp will go off.

ANTENNAS

The built-in AM Antenna and the FM Telescoping Antenna are directional. You may find that you can improve AM reception by rotating the set or bringing it closer to a window. The FM Band can be adjusted by FM Telescoping Antenna. Be sure to extend the FM Telescoping Antenna carefully to its full length for best reception.

8