INSTALLATION
DOOR OPERATION
After setup of the logs and embers is complete, the glass door must be closed. The glass door is mounted on hinges at the left side of the firebox and is secured in the closed position by two draw latches mounted on the right side of the firebox. The latch tension is preset at the factory. Over time, adjustment of the latch tension may be necessary to maintain a tight door seal. This adjust- ment can be made by spinning the latching rod in the rod guide. Care should be exercised to not adjust the ten- sion too high. Caution: Never operate the appliance with the glass door open.
If glass door removal is required for replacement or maintenance, the door can be removed Do not attempt to remove or replace broken glass in the door assembly. Contact your Lennox dealer for glass replacement. To Remove Door:
1.Remove the glass door assembly from appliance as follows:
a.Open the right and left side panels (held closed by magnets in the front. The panels hinge to back).
b.Open the two draw latches mounted on the right side of the door by pulling them forward. Swing open door. See picture in left column of this page showing their location.
c.With the door open, lift the door straight up and off the hinge pins. Set door aside.
PAGE 9
