Version 4 EQ User Guide | Configuring the |
ABOUT AUTOMATIC CALIBRATION
When running the V4 EQ software, the
The Automatic Calibration Procedures table on the next page describes all automatic calibration procedures.
BEFORE performing automatic calibration:
✓Use the CUSTOM or THX SETUP menu to set crossover points for the loudspeakers connected to the Main Zone audio output connectors. Setting crossover points, after automatic calibra- tion is performed, can invalidate calibrated output levels.
✓Set all associated component (e.g., subwoofers, loudspeakers, and power amplifiers) volume controls to a reasonable level. During automatic calibration, the
✓Eliminate extraneous noises in the listening room, including conversations, air conditioners, and sounds that filter in through open doors and windows.
✓Remove objects, including people, blocking the
DURING automatic calibration:
✓Calibrate the listening room’s bass response BEFORE calibrating loudspeaker output levels. Room correction applied to the loudspeakers as a result of the EQ DISTANCES LEVELS or ROOM EQ procedure can affect loudspeaker output levels, particularly those of the subwoofer and low frequency effect (LFE) subwoofer.
✓The
signals become too loud, press the | arrow button to cancel |
automatic calibration. |
|
✓Refer to the