Lexicon manual Connecting The Microphones, Configuring the MC-12for V4 EQ, Main Audio O

Version 4 EQ User Guide		Configuring the MC-12 for V4 EQ
CONNECTING THE MICROPHONES	Figure 2-1. Microphone input connectors on MC-12 rear panel.
Automatic calibration requires the microphones included in the		LFE		MAIN AUDIO O
Lexicon Microphone Kit, which is available at authorized Lexicon
	3	MICROPHONE INPUTS
dealers. Performing automatic calibration with other microphones
will produce unknown results.	1	2	3	4
		TRIGGER OUTPUTS
CAUTION

•	The microphones included in the Lexicon	Microphone Kit require	2. Connect the microphones included in the Lexicon Microphone
	careful handling. Dropping or otherwise	physically abusing the
			Kit to the microphone input connectors on the MC-12 rear
	microphones may cause errors during use or irreparable damage to the
			panel (shown in Figure 2-1). Make sure microphone cable
	microphones. Read and observe the documentation included with the
			plugs are fully inserted for solid connections.
	Lexicon Microphone Kit to ensure optimal microphone performance.
•	Never make or break microphone input connections unless the MC-12
	is powered off using the rear panel power switch or placed in standby
				Note:
	mode using the front panel or remote control standby button.
				During the microphone check, the MC-12 refers to
				the microphones as 1, 2, 3, and 4 based on the
To connect the microphones:				microphone input connector to which the microphone
				is connected. Label the microphones for troubleshooting
1.	Make sure the MC-12 is powered off using the rear panel			purposes.

power switch or placed in standby mode using the front panel or remote control standby button.

3. Power on the MC-12 or take the MC-12 out of standby mode.

2-5