Lexmark 4076-0XX manual Carrier Transport Motor Frame Removal, Encoder Strip Removal

4076-0XX

Carrier Transport Motor Frame Removal

1.Remove the top cover.

2.Disconnect J6 from the system board.

3.Move the carrier in line with the opening in the carrier transport motor frame.

4.Reach through the opening and pull the belt from the carrier.

5.To unlock the carrier guide rod latches, rotate the rod top-to-rear. Gently push the carrier guide rod latches, at each end of the rod, to the rear and lift up the rod until the sensor on the carrier clears the encoder strip. Remove the carrier guide rod through the opening in the left side frame. Be careful not to damage the encoder strip.

6.A latch on the top front end of each side frame holds the trans- port motor frame in place. Push up the latches on the front of the side frames and pivot the carrier transport motor frame down and out of the side frames.

Encoder Strip Removal

1.Remove the top cover.

2.Move the carrier in line with the opening on the carrier transport motor frame.

3.Reach through the opening and pull the belt from the carrier.

4.To unlock the carrier guide rod latches, rotate the rod top-to-rear. Gently push the carrier guide rod latches at each end of the rod to the rear and lift up the rod until the sensor on the carrier clears the encoder strip. Place the carrier on top of the paper guide.

5.Remove the encoder strip from the left mounting peg. To do this, push the right latch slightly to the left.

6.Remove the encoder strip from the right latch.

When you install the encoder strip, be sure it is fully seated on the left mounting peg.

36