Top Cover Removal
1.Unplug the power cord and the interface cable from the back of the printer.
2.Pull up the tab latch on the print cartridge storage unit and remove the unit from the machine.
3.Unlatch the auto sheet feed left cover by pushing it up from the bottom, then slide it off the machine.
4.Turn the machine around to remove the rear cover. Remove the screw and washer from the rear cover. Place a screwdriver in the left slot [A] and push the latch down. At the same time push the right latch [A] down.
A
A
5.Pull the rear cover out until the latches clear the top cover, then lift the cover off the base.
6.Turn the machine to the front and pull the paper tray forward.
7.Pull the top cover forward until it stops. Be sure the paper release lever clears the slot in the top cover. The operator panel cable is still connected, so carefully lift the cover off the base.
8.Set the cover down in front of the machine.
9.Pull the operator panel cable from the connector on the system board.
NOTE: When you reinstall the top cover, pull out the exit tray to pre- vent it from being trapped under the cover.
Repair Information 47
