Lexmark 47B1285, 47BT021 manual Loading the multipurpose feeder

3Flex the sheets back and forth to loosen them. Do not fold or crease the paper. Straighten the edges on a level surface.

4Load paper into the tray with the print side faceup.

Note: Make sure the paper is below the maximum fill line located on the edge of the paper tray. Overloading the tray can cause paper jams.

Notes:

•Place pre-punched paper with the holes toward the front of the tray.

•Place letterheads faceup with the header on the left side of the tray.

•Place letterheads facedown with the header on the right side of the tray for duplex printing.

5Insert the tray.

Loading the multipurpose feeder

The multipurpose feeder can hold several sizes and types of print media, such as transparencies, labels, card stock, and envelopes. It can be used for single-page or manual printing, or as an additional tray.

The multipurpose feeder can hold approximately:

•100 sheets of 75‑g/m2 (20‑lb) paper

•10 envelopes

•75 transparencies

The multipurpose feeder accepts paper or specialty media within the following dimensions:

•Width—89 mm (3.5 in.) to 229 mm (9.02 in.)

•Length—127 mm (5 in.) to 1270 mm (50 in.)

Note: Maximum width and length can be applied only to short-edge feeding.

Note: Do not add or remove paper or specialty media when the printer is printing from the multipurpose feeder or when the printer control panel indicator light is blinking. Doing so may cause a jam.

1Pull down the multipurpose feeder door.

2For paper or specialty media that is longer than letter-size paper, gently pull the extension until it is fully extended.

3Flex the sheets of paper or specialty media back and forth to loosen them. Do not fold or crease them. Straighten the edges on a level surface.

7