Manuals / Lexmark / Computer Equipment / Printer

Lexmark 522 setup guide Install memory and option cards, Accessing the printer system board

Models: 522

1 32

Download 32 pages 46.71 Kb

Page 12

Step 2: Install memory and option cards

Step 2: Install memory and option cards

Accessing the printer system board

You can customize your printer memory capacity and con- nectivity by adding optional cards. The instructions in this section help you install any of the following options:

•Printer memory

•Flash memory

•Tri-Port Adapter

•USB/Parallel 1284-C Interface Card

•Parallel 1284-C Interface Card

•MarkNet™ internal print servers (also called internal network adapters or INAs)

•Hard disk

•Optional firmware card

You must access the printer system board to install printer memory, flash memory, or an option card.

1 Make sure the printer power is off, the printer power cord is unplugged, and all cables are disconnected from the back of the printer.

2 Press the release latches to open the upper and lower front doors.

10

Image 12

Lexmark 522 setup guide Install memory and option cards, Accessing the printer system board

Contents

Setup Guide May Lexmark T522Safety information ConventionsEdition May FCC emissions informationGetting started and bracketSee page See page See pageInstall paper options and printer SetupStep 1 Install paper options and printer Installing the 2000-sheet drawerInstalling a 250-sheet or 500-sheet drawer Installing a duplex unit You plan to install memory or option cards and e Guide the print cartridge down as it drops and snaps into place f Close the upper front door3 Attach decals to any optional paper trays If you purchased optional drawers, you received a sheet of decals4 Attach the operator panel overlay are not using it, making the printer more compact Step 2 Install memory and option cards Accessing the printer system board3 Press down on the side door latches and open the side door Installing printer memory or flash memory Installing an optional firmware card Resting posts PinsCard Connectors Installing an option card 4 Unpack the card. Save the packaging materials 7 Tighten the screws to secure the cardReattaching the shield and closing the doors Step 3 Load print material Step 4 Attach cables Token-Ring networks Shielded Twisted Pair use a DB9 connector To attach the printer to a computer Step 5 Verify printer setup Turning on the printer Printing a network setup pageReady Step 6 Configure for TCP/IP Setting the printer IP addressIf your network is using DHCP, an address is automatically assigned SelectVerifying the IP settings Configure for Pull Printing ImageQuick Step 7 Install printer drivers Printer driversWindows Ports Creating ports and installing drivers Printing methodsNovell Distributed Print Services NDPS Non-NDPS queue-basedInstallation instructions Windows Supported connectionsPrinter drivers Page P/N 09H0401 E.C. 2H0000 2001 Lexmark International, Inc 740 West New Circle RoadLexington, Kentucky