Lexmark 522 setup guide Getting started, and bracket

Getting started

137.16 cm

(4.5 ft)

304.8 mm	304.8 mm
	(12 in.)
(12 in.)
508 mm	304.8 mm
(20 in.)	(12 in.)

1 Select a well-ventilated place to set up your printer. Allow at least as much space as shown in the illustration. Make sure you have a sturdy, low table or the optional printer stand on which to set the printer.

Printer

CDs

2 Remove all items from the box except the printer. If any items are missing, contact the place where you bought the printer.

Handhold	Paper bail
	and bracket

Power switch cover

Operator panel

500 sheet drawer Power cord overlay (non-English only)

Save the carton and packing material in case you need to repack the printer for ser- vice or storage.

Note: Leave the printer in the box until you are ready to install it. Then ask someone to help you lift the printer using the hand- holds.

Turn off the printer If your printer is already set up, make sure the printer power is off and the power cord and any cables are unplugged before installing any options.

Options compatibility Options compatible with the Lexmark T522TM printer are labeled with a colored triangle. Label locations are indicated in the illustrations in this book.

Troubleshooting If you encounter a problem while setting up the printer, refer to the Lexmark T522 Publications CD.

1