APPENDIX
68
APPENDIX

CLONING PROCEDURE TROUBLESHOOTING

Warning: Do not use LT2002 while a
LodgeNet PPV card is installed in TV or clone
programmer will be damaged.
Reset Clone After Static Shock
After replacing exhausted batteries, or if the programmer
behaves strangely after a static shock, activate the
internal reset switch and restore normal operation.
After a reset, check the real-time clock setting. It may
be necessary to reset the Clone Programmer clock from
a TV containing the correct time.
*Note: The LT2002 programmer is designed to be used with TVs
con-taining the 221-01006 and later processors. Use with earlier
TV sets may give unpredictable results. Processors used before the
221-01006-04 have a limited screen display capability. They
cannot display entire screens as shown in the quick setup
instructions accompanying the LT2002 clone programmer. Use the
printed menu illustrations on the quick setup sheet supplied with
the Clone as an aid to making your programming choices.
(Although the menus are not all displayed, the clone functions all
operate normally.)
IMPORTANT INSTALLER SETUP INFORMATION! PLEASE READ THE FOLLOWING...

Clone Programmer Troubleshooting

Clone Programmer
Cloning Notes: While clone is copying or transferring a master setup, do not touch or otherwise disturb clone or
connections between clone and TV. Cloning a maste r TV setup should take at least 45 seconds. Transferring the
master TV setup to the target TV should take at least 45 seconds. Monitor LED on clone to assure th at the
blinking heartbeat pattern is present throughout clone operations. After cloning, be sure to disconnect power from
the target TV for about 15 seconds.
8Only use an appropriate Installer remote to operate clone programmer with 20LH1DC1.
Wrong Installer remote.

Remote does not operate clone.

8Connect 20LH1DC1 to a reliable Analog channel signal source.
Weak signal.

Clone menu hard to read.

8Set time on a TV, copy time to Clone Programmer.
Time not available.

No time set.

8Connect M.P.I. cord.
M.P.I. cord not connected.
820LH1DC1 must be powered On for clone to work.
20LH1DC1 not turned on.
8Install 4 fresh AA high-quality alkaline batteries.
Weak batteries.

LED does not blink