CLONE PROGRAMMER LEARNING SETUP
Learning the Master TV Setup
Instructions for the Clone Programmer to Learn the Master 26LH1DC3/4/5 Setup.
Use MPI Cable to Connect LT2002 Clone Programmer to Master 26LH1DC3/4/5 MPI Port
If there is a good connection, “THE CLONE HAS CONTROL OF TV” message will appear. Press any button on the Installer remote.
Learn Setup from Master 26LH1DC3/4/5
Press 1 to select the “LEARN FROM TV” option, then press ON/OFF, POWER, or ENTER to go to the Memory Bank Selection Menu. Pick the Memory ”Bank” you want to store the master 26LH1DC3/4/5’s setup in by pressing either Channel button repeatedly to choose Memory 1, 2 or 3. (If you choose a Memory “Bank” that has a master device’s setup programmed into it, that setup will be overwritten by the new master 26LH1DC3/4/5’s setup.) Once the Clone memory bank is selected, press ON/OFF, POWER, or ENTER. The Clone memory bank you have selected will be shown. Press ON/OFF or POWER to begin copying the master 26LH1DC3/4/5’s setup.
Set the Clock (Optional)
Set the time on a Master TV’s Clock. (If the time has already been copied from a TV into the Clone programmer, you can set a master TV’s clock by copying the time from the Clone programmer.) The Clone Programmer can copy the current time to both a master TV and to the Clone’s internal clock; accurate to within one minute. (Another reason that the Clone programmer should be equipped with fresh,
Since the Clone Programmer’s time cannot be set directly, the current time needs to be copied from a LG TV equipped with M.P.I. input capability.
After the time is copied to the Clone programmer, the current time can then be transferred to another TV. (This can be a master TV, or another TV which has already had the features set up.)
*Note: When using the clone programmer for teaching or learning,
be sure that the heartbeat pattern is shown on the LEDs. Both learning and teaching should take about 45 or more seconds depending on the complexity of the master setup. While the clone is functioning, do not move it or otherwise disturb the clone or wiring connections. If the clone finishes the function in less than 45 seconds, redo the function again. Press the reset button if the clone does not act normally.
THE CLONE HAS CONTROL OF THE TV
THE CLONE IS VERSION | XX |
THE TV IS VERSION | XX |
THE SW IS REVISION | XX |
CLONE CLOCK= | XX:XX |
TV CLOCK= | XX:XX |
This menu should appear by itself after the LT2002 is connected to the 26LH1DC3/4/5 MPI port.
CLONE SELECTION MENU
(1)LEARN FROM TV
(2)TEACH TO TV
(3)SET CLONE CLOCK FROM TV
(4)SET TV CLOCK FROM CLONE
(5)DISPLAY TV SETUP
(6)DISPLAY CLONE SETUP
-TO CHANGE MENU ITEMS, PRESS CHANNEL KEYS OR DIGITS.
-TO EXECUTE ITEM, PRESS ON/OFF, POWER, OR ENTER
LT2002 Clone Programmer Communication Problems
•A slow flashing green light indicates there are communication problems between the 26LH1DC3/4/5 and the LT2002 clone pro- grammer. If this is the case, check for a dam- aged cable, poor contacts, or other connection troubles.
•If the status indicator is red, the programmer batteries are low and should be replaced. Install 4
COMMERCIAL MODE
55
