LG Electronics 3600 operation manual Striping Operation, Refer to figure below

Striping Operation

1. Choose handle location

The choices are, installing the handle opposite of the single wheel assembly (standard set up) or placing the handle directly over the single wheel assembly. The handle location is really a matter of personal preference, however having the handle away from the single wheel assembly allows for easier loading/ unloading from a van or truck.

2. Cable Tension Adjustment

Once the handle and gun arm assemblies are set up to the preferred positions, pressurize the unit and trigger each gun to ensure that they activate and release correctly. If not, adjust the cable tension as follows:

a.Locate the adjustment knobs on the base of the gun trigger, where the cable connects to the gun trigger assembly.

b.Loose the locking nut & move the adjusting screw until the slack has been removed from the cable.

c.Tighten locking nut and retest gun triggers for proper function.

Note: There is an additional cable adjustment where the cable attaches to the gun holder assembly. Use only if the gun trigger adjustment is insufficient.

4.Setting the Swivel Wheel with RADIUS MEMORY™

Refer to figure below

a.Pull back on the swivel wheel trigger to adjust the wheel to desired angle.

b.To set the angle for constant arch loosen the jam nuts on the Turnbuckle. Place Turnbuckle onto the mounting nub located on the striper frame.

Adjust the turnbuckle until it fits over the mounting nub located on the wheel frame. Tighten jam nuts on the turnbuckle to affix the length.

Note: If you have archs that you paint regularly, purchase additional Turnbuckles (P.N. 136-163) and keep them set to those arc sizes for easy use.

Wheel Release

3. Miscellaneous Operations

CURBS: To paint at a 90 degree angle to spray the sides of curbs install a part # 032-028 swivel between gun head and tip guard and aim guard sideways towards the curb.

WIDE STRIPES: Install wider fan striping tips and raise the gun height to achieve the desired width line.

STENCILS: Install standard spray tip on the outer gun. Rotate gun to remove from the gun holder and use the gun to spray within your stencils. Use of an extension pole will make this job a lot easier on the operators back and is highly reccomended.

STANDARD PAINTING: Install the appropriate size and type of paint spraying tip (standard paint spray, “W” wide pattern, or “Fine Finish”). Remove gun and spray just as you do for stencils. Additional paint hose may be required depending on the distance between the job and the equipment.

Turnbuckle

Mounting Nubs

13