16 206-4214
Custom Master TV Setup (Cont.)
2. Set Installer Menu items.
This step provides specic instruction only on the Installer Menu items
that should be set on a Master TV. Refer to pages 19 to 27 for detailed
information on all Installer Menu items.
a) Use the Installer Remote to access the PTC Installer Menu (see
“Accessing the Installer Menu” on page 19 for further information).
The next step depends on whether the Automated Installation
Routine Wizard appeared when you turned ON the TV:
• If the wizard did appear, the TV is in a factory default state, and
you can proceed to set Installer Menu items. Go to step (c).
• If the wizard did not appear, go to step (b).
b) Set Installer Menu item 117 FACT DEFAULT to 001 and press
OK on the Installer Remote.
This clears all Installer Menu custom settings, channel lineup, etc.
and restores the factory default settings. The value will change
back to 0 after the PTC has been restored to factory default
condition. This step ensures that the TV Channel Memory will be
the active channel lineup.
c) Set Installer Menu item 003 BAND/AFC, as appropriate.
• Broadcast: Set to 000. • HRC: Set to 002.
• CATV: Set to 001 (default). • IRC: Set to 003.
d) Set any other Installer Menu items that affect your TV programming
network to the required conguration. For example, enable/disable
Aux inputs, set a Start Channel, etc.
Note: If you intend to use a USB memory device / .tlx le for
cloning purposes, you may also congure selected settings in the
IP Environment Menu (accessible from the Installer Menu). See
also “Cloning Methods” on the previous page and “IP Environment
Setup” on pages 49 to 55 for further information.
e) After you have adjusted all Installer Menu item settings as required,
press OK once on the Installer Remote to save your changes; then,
press OK again to exit the menu.
Note: If you performed step (b) above to restore factory defaults,
the Automated Installation Routine Wizard will re-activate as soon
as you exit the Installer Menu. Exit the wizard (see step 1), and
then continue with step 3.
(Continued on next page)
Typical Installer Menu
Note: The Installer Menu header will vary
depending on the TV you are setting up.
Adjust the values for these
Installer Menu items, as required.
xxLT770H PTC INSTALLER MENU
CPU-CTV
000 INSTALLER SEQ 000
UPN 000-000-000-000 ASIC D279
PTC V1.00.009 CPU V3.04.00
117 FACT DEFAULT 000
003 BAND/AFC 001
Custom Master TV Setup Procedure
1. Turn ON the TV.
If the Automated Installation Routine Wizard appears on the screen when you turn ON the
TV, use the Up/Down arrow keys on the Installer Remote to select Exit from the Welcome
screen, and press OK to exit the wizard.