11
206-4214
The Automated Installation Routine Wizard will appear on the screen each time the TV is turned ON, until
one of its conguration methods has been completed or the wizard is exited.
The wizard’s Welcome screen provides a selection of conguration methods: Auto or Manual options for
conguring essential items for Pro:Centric operation and also an option for using a USB memory device
to congure the TV for FTG Mode via CPU. This section describes each of the Automated Installation
Routine Wizard options.
Pro:Centric Manual
Welcome
Please select configuration method.
USB Configuration
Exit
OK
Move
Pro:Centric Auto
Before you begin, note the following:
• If it has been completed or exited and therefore does not display, the Automated Installation Routine
Wizard can be re-activated; however, this requires that factory defaults be restored on the TV(s). Refer
to Reference section, “Restoring Factory Defaults on the TV(s),” for further information.
• If you plan to create a Master TV Setup using the procedure described on pages 15 to 18, be sure to
exit the Automated Installation Routine Wizard in order to avoid setting modes that may restrict the
custom setup procedure.
• If any of the conguration steps fails, you will see an “Incomplete” screen with an indication of the
failure. You will then have the opportunity to reinitiate the current conguration process, select another
conguration method (for example, to select Pro:Centric “Manual” instead of “Auto” conguration), or
exit the Automated Installation Routine Wizard.
• If you wish to enable media sharing (i.e., Smart Share and Wi-Fi Screen Share) on the TV, you will need
to create a custom Master TV Setup and use the IP Environment Menu to specify the settings. Custom
Master TV Setup is described on pages 15 to 18. Refer to “IP Environment Setup” on pages 49 to 55 for
information on the IP Environment Menu.
• If you need to specify a zone restriction for the TV, you will need to create a custom Master TV Setup
as described on pages 15 to 18 and specify this setting in the TV setup menus. See also Reference
section, “TV Zone Restrictions,” for further information. Note that the zone restriction is not clonable.
Caution: Do NOT unplug the TV power cord or remove the antenna cable during any of the
conguration processes, as doing so will interrupt the current step and may corrupt the
conguration data.
To exit the Automated Installation Routine Wizard, use the Up/Down arrow keys on the Installer
Remote to select/highlight Exit. Then, press OK.
Automated Installation Routine Wizard