53
206-4214
IP Environment Setup (Cont.)
Pro:Centric Setup
Pro:Centric options enable you to congure the TV with the appropriate settings to connect to the
Pro:Centric server. Use the Up/Down arrow keys on the Installer Remote to navigate between
elds.
1. With the IP Environment Menu on display, use the arrow keys on
the Installer Remote to select Pro:Centric. Then, press OK.
Note: Options that are initially grayed out/inaccessible in the
Pro:Centric Menu are dependent upon other settings in the display.
For example, if “IP” is selected in the Media Type eld, the Server IP
and Port Number elds become accessible.
2. Refer to the appropriate subsection(s) below to congure the
TV’s Pro:Centric settings to match those of the Pro:Centric server.
While the Pro:Centric application (Mode) itself is an additional feature,
the appropriate Pro:Centric server conguration must be completed
to enable TV E-Z Installation (splash screen, conguration, and/or
rmware) data downloads and, if congured, the Pro:Centric
application download.
Note: For those elds that permit direct entry of numerical values (for
example, Server IP, Port Number, Data Channel, etc.), once you key in
the maximum number of digits allowed in the highlighted eld, the next
available eld will be highlighted.
RF Conguration
1. In the Media Type eld, use the Left/Right arrow keys to select RF.
Note: If the Media Type has already been set in the Automated Installation Routine Wizard, the
specied value will be reected in this eld.
2. In the Data Channel eld, either key in or use the Left/Right arrow keys to select the RF
channel number for the Data Channel of the Pro:Centric server. The Data Channel can be set
from 0 (disabled) to 135.
Note: If the Data Channel has already been set in the Installer Menu (Installer Menu item 119
DATA CHANNEL) or in the Automated Installation Routine Wizard, the specied channel will
appear in this eld. If you change the Data Channel in this menu, Installer Menu item 119 will
now show the value you entered here.
3. In the Wake On RF eld, use the Left/Right arrow keys to select On or Off, as required. The
Wake On RF feature enables the TV to receive software updates via RF while the TV is in
standby mode. If you set Wake On RF to “On,” specify the appropriate Wake On time in the
Wake On Time eld. Note that the Wake On time is based on a 12-hour clock. Ensure the AM/
PM specication is set accordingly.
4. Once all elds are completed as required, either select Close and then press OK on the Installer
Remote or press to return to the IP Environment Menu.
0
0ff
<
<>
>
RF
<>
Close
Mode
Media Type
Server IP
Port Number
Data Channel
Wake On RF
Wake On Time
0 0 0 0
0
<>
On
<>
12 AM
<>
00
<>