42 206-4214
Teaching FTG Conguration to a TV
This section describes how to “Teach” an FTG Conguration le from a USB memory device to a TV.
Ensure you have completed the procedure on the previous page to create the FTG Conguration le
before proceeding with the steps below.
Notes: • If the TV EBL is already in FTG Mode, you cannot use this procedure to make changes to
the FTG Channel Map and FTG Installer Menu settings. You must use a direct PC-to-TV
connection as described in Reference section, “FTG Mode via EBL (Local Conguration),” or
an FMA head end device to recongure the EBL.
• If the preceding condition applies, but you wish to switch the TV to FTG mode via CPU,
refer to Reference section, “Restoring Factory Defaults on the TV(s),” for further information
before proceeding.
FTG Mode via CPU (Cont.)
Note: If the Automated Installation Routine Wizard appears on the
screen when you turn ON the TV, you can use the “USB Conguration”
option to congure this TV, if desired (see “USB Conguration” on page
14).
1. Turn ON the TV, and then plug the USB memory device that
contains the FTG Conguration le into the Target LT770H TV USB
IN port.
2. Press MENU SETTINGS on the Installer Remote to display the TV
setup menus (TV is in Pass-through Mode) or the Function Menu
(TV is already in FTG Mode).
3. Use the arrow navigation keys to select/highlight either the Option
menu icon from the TV setup menus or the Lock menu icon from the
Function Menu. Then, press the number “7” key a total of seven times
to display the USB Download Menu.
4. Use the Up/Down arrow keys to select Teach To TV (TLX), and then
press OK.
5. Use the Up/Down arrow keys to select the FTG Conguration le
you want to install, and then press OK.
Teaching status will be shown on a progress bar in a new window.
Do NOT remove the USB device until Teaching is complete. When the
Teaching process is complete, the TV will briey display a “Teaching
Completed” window and then exit the USB Download Menu.
6. Remove the USB memory device from the Target TV, and verify that
the FTG Configuration is resident on the Target TV.
The Target TV CPU is now in FTG Mode (if it was previously in Pass-
through Mode).
Note: After the Teaching process is complete, the TV tunes according
to the Start Channel setting in the Installer Menu. If a Start Channel is
specied, the TV will tune to that channel; otherwise, the TV will tune to
the lowest logical channel in the FTG Channel Map.
USB Download Menu
Upgrade TV Software
Upgrade PTC Software
Teach To TV (TLL)
Teach To TV (TLX)
Previous OK
Teach To TV
UPDATING...
Do not unplug!
50%
Teach To TV (TLX)
Previous OK
xxLT770H-UA00005.TLX